订阅以下载
VC Rough Industrial Quay

Quays this narrow are less than or near the width of the underlying ground mesh. So the ground mesh has difficulty conforming to the rapid change in slope. I would assume this is why the vanilla quays are so wide. Way beyond what could be considered scale.

Ah, my bad. I´ll figure out another way to use it later then. :) *goes back to read the instructions one more time* I think I read it... but forgot about it.

you might want to read the previous comments. This quay is narrow for more tight places. place a .5 meter terraforming network on the water side, adjust its distance from the quay then wiggle the quay a little bit and those gaps should disappear. This happens because the width of the quay is so narrow. You get these gaps with all quays, wider ones just cover it up

https://cdn.discordapp.com/attachments/268042746839695361/929760937932644432/unknown.png and here is a link to a picture showing what I mean.

I am seeing some glitches when I place this quay. On the inside of it, opposite the water, I can see through the ground along the entirety of the quay. Its like a 1 cm opening. If I pan around the camera from the other side I dont see it. Its only from the seaside I i see it.

LOOKS SO MUCH BETTER FOR MY OIL DOCKS :-)

@LDTailor using the terraforming networks is an exercise of fiddling as each segment depending on height, curves etc ends up unique. Play around with the different sizes as well.

@VecchioChristo It's like you heard my right before bedtime tears and swooped in to save the day like Santa Claus!

I get those gaps all the time, you just have to push and shove the quay a little to make them disappear.

And thanks for the additional info. I'm not wot working on map editor at the moment. But will try the terraforming networks.