商店页面
Barotrauma 潜渊症
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Barotrauma 潜渊症

商店页面
Barotrauma >  创意工坊 > badgerman 的创意工坊
评价数不足
Ballast Flora Cutoff
描述 讨论0 留言14 改动说明
   
奖励
收藏
已收藏
取消收藏
Item Assembly
文件大小
发表于
更新日期
60.094 KB
2021 年 2 月 5 日 下午 10:18
2021 年 2 月 8 日 下午 7:50
2 项改动说明 （ 查看 ）
创建者
badgerman
离线
查看所有 45 个合集（也许有些被隐藏了）
2,227 不重复访客数
337 当前订阅者
39 当前收藏人数

订阅以下载
Ballast Flora Cutoff

描述
A simple switch to get pumps ready for flora extermination. The toggle switch 1. Disconnects the navigation terminal 2. Sets the pump to drain 3. after it has completely drained turns off power to the pump. Use a Flame, incindiary grenade or plasma cutter to exterminate the flora.
14 条留言
< >
WaveMaker 2022 年 5 月 9 日 下午 11:53 
The setup was worth it
kellym 2021 年 12 月 16 日 下午 10:22 
@Cаник: thank you so much for your help -- I appreciate it
MinoYkladShek 2021 年 8 月 4 日 下午 1:12 
the problem with this scheme is that in the leftmost component of the signal check, the values of the output (should be 0) and the false output (should be 1)are mixed up:captainsmooth:
MrBadman 2021 年 5 月 15 日 下午 5:48 
if iam wrong any advices? connected as said and it just turn off pump but water dont drain
MrBadman 2021 年 5 月 15 日 下午 5:22 
thanks by the way
MrBadman 2021 年 5 月 15 日 下午 5:22 
There's a mistake in middle label. Sig1_out to Pump Set_Speed / Sig2_out to Pump Set_state(here should be toggle_state) otherwise it doesnt work fine:BEjoyful:
Squid 2021 年 2 月 27 日 上午 11:50 
Thank God someone made this, thanks bro.
badgerman  [作者] 2021 年 2 月 14 日 下午 1:04 
The water detector goes at the bottom of the ballast. There are labels in the item as to where the nav terminal wires in. You need to read the labels and then find the nav terminal and the pump and attach the way the labels tell you. 'Sig1' is short for 'signal 1'.
Wildly Unprepared 2021 年 2 月 13 日 下午 11:22 
Well that precisely is the question. which room should the water detector be? the ballast? I think we need to wire to the navigation terminal, but i don't understand to what. Even just one extra image with a very simple drawing would be more than enough, at least for the more clueless on the more advanced wiring methods
thanks
Flimbo 2021 年 2 月 10 日 下午 8:41 
i put the water detector on the floor and as for the wiring i just went into wiring mode and poked around a bit