订阅以下载
'Goose' Miner Transport Truck [Vanilla] [Survival Ready]

Creative version can be found here

Suggestions for changes to the design, talk to Splitsie.
Suggestions for improving ease of printing and setup, let me know.

This blueprint is ready for projection and printing in Survival.
A little extra work is needed after printing however.

You'll need to build the Trailer Jack Pistons first (see 2nd image for reference) by attaching a small head to the rotor on either side of the trailer nose then placing a corner blast door piece, piston, and blast door edge piece. PLACE THESE SO THEY ARE VERTICAL AS THE ROTORS ARE LOCKED IN THE DOWNWARD POSITION. You'll then need to group the pistons as "Trailer Jack Pistons" and extend them till they touch the ground.

Next you'll grind off the RED colored blocks attaching the truck to the trailer. You can then extend the pistons further to raise the nose of the trailer up enough to build the trailer hinge setup. To build the Trailer Hinge setup (see 2nd image for reference), attach a small head to the rotor on the rear of the truck (rotor SHOULD already be locked). Attach the blast door corner pieces and rotors as shown and lock each rotor as you build them. Grind off the head from the last rotor and attach the head on the trailer to the last rotor. The trailer will now be attached to the truck and you can fold up the Trailer Jacks.

You'll need to add a few things to the toolbar in the cockpit as follows:

Toolbar 2:
Trailer Jack Rotors (Reverse) [Should already be on the toolbar]
Trailer Jack Pistons (Reverse) [Be sure to set the speed and max distance on the pistons]
Trailer Hitch Rotor Roll (Lock/Unlock) [Should already be on the toolbar]
Trailer Hitch Rotor Roll (Detach) [Should already be on the toolbar]
Trailer Hitch Rotor Roll (Attach) [Should already be on the toolbar]

One last thing to do, add small heads to the rotors on top of the trailer and build spotlights on them.