订阅以下载
LEC P&D-Series Missile Pod M-Mk.2

Mod free, block group free, survival ready
Gatling version: https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2249302104

The Mark 2 Missile pod comes equipped with two missile turrets and two large batteries that (when fully charged) give it enough power to remain on standby for 18 days.
It is intended to be printed by a 3D printer with a merge block, and then be loaded with ammo through a connector before being left behind at a location of your choosing.
The Blueprint spawn comes loaded with 32 200mm missiles.

After the merge block the drone has been printed on is disabled it will start two timers:
- a 2 second timer that locks the connector, which gives it time to magnetize to a connector of the mothership (build your setup accordingly!)
- a 5 second timer which activates the second sensor
after this 5 second timer has run out the drone will be primed, if it is now *at any point* unlocked from the mothership connector it will activate its thrusters and fly forwards for 12 seconds, a distance of about 89m. At this point it will come to a halt and activate its turrets to await engagement with an enemy.

Turret Alert
The Mk.2 Missile Pod will automatically turn on a 50km beacon if it engages an enemy. This allows these pods to act as an early warning system or to let your enemies attract some... other attention.
The beacon deactivates once the pod stops shooting (or is destroyed, which means it stops shooting)
This script works both with and without weaponcore!
A big thank you to Foltast for writing this script on my request! Check it out here: https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2241293385




Blocks: 32
Non-armor blocks: 32
PCU: 927
Conveyors: 18
Thrusters: 13
Lights: 0
Spotlights: 0
Gravity Generators: 0
Artificial Masses: 0
Triangles: 331.845
Grid mass: 9.264

Integrated Scripts:
Turret Alarm: https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2241293385

Want to see a massively over-complicated setup of how such a 3D printer could work?
https://youtu.be/Uegyj334QeI
Seriously, you could do a much simpler design...