订阅以下载
ISL - Tetra MK3-IC 1050 Salvager

A medium size ship for grinding jobs, either manually or automated with the PAM script. The MK3 has a wider range of operating environments than its MK 1 counterpart, although it is bulkier.

Tools, Scripts & Weapons:
3 grinders
PAM script

Power:
6 Large Batteries
15 Small Batteries

Movement & Control:
1 Cockpit
1 Remote Control
5 Gyroscopes
6 Large Atmospheric Thrusters
30 Small Atmospheric Thrusters
12 Large Ion Thrusters
12 Small Ion Thrusters

Cargo Space
3 grinders
1 medium cargo container
2 connectors - underside and rear

Miscellaneous:
1 Sensor (for use with PAM)
2 Spotlights
Navigation Lights
Repair Projector

This ship has an empty mass of 74506 kgs, and can move with a full cargo at a maximum tilt of 50 degrees below horizon.

All Programmable blocks are turned off in this blueprint and all toolbars are the same from the cockpit and remote control.

All ships in this set have a rear mounted Merge block and can be printed using a welder wall with one (large grid) piston. However in this design the merge block will have to be ground down if docking via the rear connector, all blocks that require removal are painted bright red.

Toolbar 1
1. Thrusters All On
2. Thrusters All Off
3. Thrusters Braking On
4. Thrusters Braking Off
5. Lights On/Off
6. Connector Switch Lock
7.
8.
9.

Toolbar 2
1. Battery Discharge
2. Battery Recharge
3. Camera Front
4. Camera Underside
5. Camera Rear
6. Grinder Control
7. Grinder On/Off
8.
9. Antenna Broadcast On/off

Toolbar 3
1. PB [PAM] "up"
2. PB [PAM] "down"
3. PB [PAM] "apply"
4.
5. PB [PAM] "Align"
6. PB [PAM] "homepos"

Toolbar 6
1.
2.
3.
4.
5. Repair Projector On/Off