订阅以下载
ISL - Syngna Tunnel Miner MK2-AO 240

A very small, cheap miner to bridge the gap between hand drilling and the Tunnel Miner series. The Syngna (Sig-nah) series features only one drill, but is able to fit inside the tunnel it excavates, and can be used with the PAM script. The MK2 also features additional cargo space and a stone ejection system.

Tools, Scripts & Weapons:
1 Drill
PAM script

Power:
1 Large Battery
19 Small Batteries

Movement & Control:
1 Cockpit
1 Remote Control
1 Gyroscope
18 Small Atmospheric Thrusters


Cargo Space
1 Medium Cargo Container
2 connectors

Miscellaneous:
Stone Ejection System
1 Ore Detector
1 Sensor (for use with PAM)
2 Spotlights
Repair Projector

This ship has an empty mass of 22723 kgs, and can move with a full cargo at a maximum tilt of 45 degrees below horizon.

All Programmable blocks are turned off in this blueprint and all toolbars are the same from the cockpit or remote control.

All ships in this set have a rear mounted Merge block and can be printed using a welder wall with one (large grid) piston. However in this design the merge block will have to be ground down if docking via the rear connector, all blocks that require removal are painted bright red.

Toolbar 1
1. Thrusters All On
2. Thrusters All Off
3. Thrusters Braking On
4. Thrusters Braking Off
5. Lights On/Off
6. Connector Switch Lock
7.
8.
9.


Toolbar 2
1. Battery Discharge
2. Battery Recharge
3.
4.
5. Camera Rear
6. Drill Control
7. Drill On/Off
8. Ore Detector
9. Antenna Broadcast On/off

Toolbar 3
1. PB [PAM] "up"
2. PB [PAM] "down"
3. PB [PAM] "apply"
4. Ejector System On/Off
5. PB [PAM] "Align"
6. PB [PAM] "homepos"

Toolbar 6
1.
2.
3.
4.
5. Repair Projector On/Off