订阅以下载
Hold position+reset to default position [OLD]

This is an old and unefficient blueprint, do not use it as there are far better methods (use an accumulator)

Allows to have a servo/hinge hold its position while still being able to make it go back to neutral position with a button press

Connect the red gate to the servo/hinge and remove the keybinds from it, you can change keybinds to rotate the servo/hinge on the green gate and the keybind to reset it on both of the yellow gates. The speed of the servo/hinge must be low (0.1) in order for it to be stable