Kerbal Space Program

Kerbal Space Program

评价数不足
V-5-G12 Grasshopper VTOL
   
奖励
收藏
已收藏
取消收藏
Craft
Craft Type: Plane, Robotics
文件大小
发表于
186.099 KB
2019 年 6 月 29 日 下午 5:19
1 项改动说明 ( 查看 )
您需要 DLC 才能使用该物品。

订阅以下载
V-5-G12 Grasshopper VTOL

描述
MODs: OPT and Reusability at minimum

1. Toggle Engine Mode
2. Toggle Engine Gimbal
Translate Up/Down (K/I) : Engine tilt Fore/Back
G: Retract Legs


Flight Tips:

Recomend enabling SAS for all flight.

Neutral Throttle Lift ~50%-66%

Hovering: Engine tilt acts like the cyclic on a helicopter. Use it to control speed fore and back while nose-level. Roll required for side speed.

Accelerate in forward Flight: From a hover, tilt engines forward (so they point backward) to build speed. Continue to gradually tilt forward and increase throttle. At around 75m/s disable engine gimbal to reduce part juttering. Maintain level nose and keep an eye on ascent speed and vector. Control this with engine tilt. If vector is below horizon, tilt engines back (point downard) to gain lift. The opposite applies to reduce lift.

Decelerate from forward flight: Reduce throttle to 50%. At ~200m/s tilt engines full back. Use pitch up to further reduce forward momentum. Maintain altitude above 100m until below 75m/s.
2 条留言
DOOT 2019 年 8 月 29 日 下午 11:06 
what mod for the cockpit?
-Helic0- 2019 年 8 月 14 日 下午 5:23 
any mods?