订阅以下载
MW3 M16A4 (for SCAR)

Colt M16A4 from CoD: Modern Warfare 3. A version of the M16A2 with a removeable carrying handle, doing so would reveal the Picatinny rail for alternative sights or scopes. Typically, the factory handguard is replaced with a quad-rail one which allows installing more gadgets like LAMs or vertical grips.


Ooh, boy. This one was just painful to look at, the model almost appeared irredeemable. It was obviously built off the game's custom M4A1 base, and fell into the AR-15 Uncanny Valley for too many reasons. The stock was attached via the same tube as the M4, even exposing a part of it, like a fugly "pin roll". The receiver retained the rail riser and the carrying handle was sitting on top of it; this is why the modelers made it smaller. The magazine was also reused, except it was reshaped into a banana or a boomerang; I have given it the game's SCAR-L magazine instead. The handguard was two M4 handguards obviously stitched together and extended to the point it covered the gas block; I made the stitch less obvious by mirroring the texture and covering it with zip ties, and exposed the gas block. I have also made the flash hider smaller as the original looked like it could launch miniature nukes. What I couldn't really fix is the fire selector being set to "look I just broke the fire selector";[www.imfdb.org] the genius texturers actually put it into the friggin' texture this way!

Constructive criticism is welcome. Think twice before posting complaints or suggestions.

Models/textures: whichever twisted mind creates frankenguns at Infinity Ward/Sledgehammer Games/Raven Software (distributed by Activision)
Animations: arby26
W_model mag fix: Lt. Rocky
Compile: Alex_D_Vasilkov
Sounds: Infinity Ward, reload only, link for MW3 M16A4 firing sound[www.gamemaps.com]

https://www.gamemaps.com/details/20904

Copyright 2022 Alex_D. This item is not authorized for posting on Steam (or anywhere else, unless fully credited), except under the Steam account named Alex_D_Vasilkov.