订阅以下载
Mainline Left Switch 1

That makes sense. Thanks!

Instead of welding the switchstand to the sleeper, mount it to a bearing. Make sure the bearing is set to 45 degrees and you'll be set.

Ok, i did this and it worked, but how do you install a switch on a 45 degree angle>

On the longest sleeper of Lord Pain's track switch assets, put down a block that touches both the sleeper and the outside of the straight rail. Then, weld the switchstand to it. You can then get rid of that block you placed earlier, but you may need to put some blocks underneath the switchstand to anchor it to the ground if its visibly floating. I'd also recommend disconcerting the sensor, as it doesn't always work.

By install I mean put them on the track

How do you install these?