Abonner for at downloade
SH-3 Sea King - Fire Rescue Version (Outdated)

This is the fire fighting & rescue version of the SH-3 Sea King helicopter I built earlier. Included is a bambi bucket for fighting fires. Bucket can be connected to the winch through an electrical connector with composite logics to fill/empty bucket and show water level/capacity from inside the chopper cabin.


https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1600936583



- Working dual pilot seats
- Altitude hold
- Auto retracting/extending landing gears w/ landing lights
- Starboard exterior winch for rescue operations
- Large cabin winch for lifting or towing cargo
- Retractable search light (angle adjustable)
- Sliding side doors



- Fuel : 5088 liters
- Top speed : 67 knots
- 2 crew, 3 passenger seats
- 1 medical bed



1. Turn on engine start
2. Wait 60 seconds or till engine RPM reaches 2000+
- Initial throttle is set at 50 and doesn't require more power for flight
- Battery generator automatically engages at 200 RPM
3. Release landing gear brakes
4. Tap W to exit hangar
5. Press Up to lift off
6. Fly off into the sunset
7. In case battery runs out due to prolonged inactivity :
- Use emergency power switch located next to port(left) wheel
- Or connect external power source to electric connector above tail wheel



1. Open winch hatch inside chopper, extend winch cable
2. Grab connector from underneath chopper, climb up to the top of the bucket and connect to bucket connector
3. Fly to water source, press altitude hold and fill up water bucket
4. Fly to fire and empty water bucket
5. Careful not to fall out of the hatch!