商店页面

Space Engineers

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Space Engineers > 创意工坊 > MaXiMuM4D 的创意工坊

评价数不足

Wheeled Explorer (Vanilla)

描述讨论0 留言3 改动说明

奖励

Type: Blueprint

文件大小

发表于

1.271 MB

2018 年 7 月 26 日下午 4:46

1 项改动说明（查看）

828	不重复访客数
189	当前订阅者
16	当前收藏人数

订阅以下载
Wheeled Explorer (Vanilla)

已订阅

取消订阅

描述

Introduction

As a pilot you are in control of this vehicle. To make it to your destiny in
one whole part, you should take care of the following guidelines:

You can us "x" (if not reassigned) to charge a jump, using your
Wheel suspensions.
!!!CAUTION!!! Do not charge to much, it's strong.

The vehicle horn is limiting you to a certain degree of steepnes, that
means:

"If your nose can't pass, you should change or correct your path"

usually, you can climb any wall at ~30m/s, without destroying the Front.

Unless it's a hilly area, you can travel at a rough speed of 100m/s.

The handbrake (Usually "spacebar") is very effective, use it!

I'm not sure if it's supposed to be like that (it would would make sense tho,bcs of the thrusters) but:

Spacebar works in midair , which means you can brake while flying.

Pilot Controls:

1. Front Lights On/Off
2. Outside Lights On/Off (Camoflage)
3. Open / Close Airtight Doors
4. Hangar Platform Up / Down
5. Hangar Platform Open / Close
6. Platform Rotos Lock On/Off (For more stable behaviour)
7. Air Pressure On/Off
8. Connector switch lock
9. Suspension Airshock On / Off

This vehicle is completely vanilla, airtight and survival ready

3 条留言

< >

MaXiMuM4D [作者] 2018 年 7 月 29 日下午 2:37

@not442 , idk what you mean, you will have to rebuild it with the help of the original. All pistons are named, it should be easy to follow it.

But here is how I would build it:

Choose (for example) the left BIG rotor, attach the pistons and the small rotor to it ( build it), then build the platform from there.

When the Platform is finished, put a rotorpart on the block, where the second rotor (which u didnt build yet) would normally be.

Now finish the other side (the other big rotor), build the pistons and the small rotor, and remove the small rotors rotorhead once u build it.

now align the rotorpart that u build on to the platform, and the small rotor which is not connected to it (yet). You should be able to "attach" the rotor part to the small rotor in the rotor menue (same menue where u detached the old rotor part)

Let me know if it worked for you

Rotol 2018 年 7 月 29 日下午 2:10

It looks great and behaves good for its size. But how can I weld the parts connected to the rotors in survival?

MaXiMuM4D [作者] 2018 年 7 月 27 日上午 8:44

Also leave a comment or a rating if you liked it. i'm lonely and depressed : - )

< >

Space Engineers

订阅以下载Wheeled Explorer (Vanilla)

编辑链接

订阅以下载
Wheeled Explorer (Vanilla)