Butiksside
Space Engineers
Alt Diskussioner Skærmbilleder Illustrationer Broadcasts Videoer Værksted Nyheder Guider Anmeldelser

Space Engineers

Butiksside
Space Engineers >  Værksted > Timotei~s værksted > MArmOS (Mechanical Arm Operating System) v3.1 > Diskussioner
MArmOS (Mechanical Arm Operating System) v3.1
Beskrivelse Diskussioner22 Kommentarer606 Ændringsbemærkninger
DazeyDream 8. nov. 2022 kl. 18:35
Can I get a clear explanation on solids?
I'm not a programmer so I barely know what's going on. I figured out how to set up the arm but they're acting wrong. I try to follow the examples of some workshop examples but I'm still falling short on achieving their accuracy and stability and I don't know what I'm doing wrong. I figure its to do with solids since I dont understand what they even are and how I should be doing them. So please, a clear and precise explanation on what solids are and where I should be putting them would be very very helpful!
< >
Viser 1-1 af 1 kommentarer
K-Duke 15. nov. 2022 kl. 11:15 
Solids are the binding elements between the active parts of an arm.
They simply describe the distance from one rotor to the other.


If you have a setup like this:

+ is a rotor
= is a simple armor block

Assume that to the right you got positive X direction
Assume to the bottom you have positive Y direction

0123456789 0 +== 1 == + 2 ==+====
This would result in SolidSG( 5, 2, 0 ) since you have to go from the middle of the first rotor 5 blocks to the right to reach the second rotor. Also you have to go 2 blocks down.

Then to get from the second rotor to the third it is SolidSG( 4, -1, 0) because you go 4 to the right and one up.

So you pretty much place solid between every rotating part in your arm. Interestingly pistons themself count as solids as well, counting the length of it in blocks when it is completely retracted.
Sidst redigeret af K-Duke; 15. nov. 2022 kl. 11:19
#1
< >
Viser 1-1 af 1 kommentarer
Per side: 1530 50