Trang cửa hàng
ARK: Survival Evolved
Tất cả Thảo luận Ảnh chụp Tranh ảnh Phát sóng Video Workshop Tin tức Hướng dẫn Đánh giá

ARK: Survival Evolved

Trang cửa hàng
ARK: Survival Evolved >  Workshop > Workshop của ExileAcid > Castles, Keeps, and Forts (Legacy) For new version go to Castles Keeps and Forts Remastered. This version still works > Thảo luận
Castles, Keeps, and Forts (Legacy) For new version go to Castles Keeps and Forts Remastered. This version still works
Mô tả Thảo luận299 Bình luận4667 Ghi chú thay đổi
restles5nativ3 10 Thg05, 2017 @ 10:49am
Windmill
Love the mod. Cant get the Windmill driveshafts to snap to the Windmill itself and the Millstone wont snap/place to the foundations or ceilings. Didnt use it before the update (257) and I am on the Island.
< >
Đang hiển thị 1-6 trong 6 bình luận
eNc | Henrik 10 Thg05, 2017 @ 3:16pm 
Use the four way driveshaft from the windmill and then continue from there. The top of the millstone will snap to a driveshaft when it has connection with a foundation or ceiling.
#1
restles5nativ3 10 Thg05, 2017 @ 4:39pm 
ok, I did notice it was the only one to connect but it sticks out through the wall so wasnt sure if that was right or not. thanks for the reply
#2
Snicker 17 Thg05, 2017 @ 5:13pm 
Yeah, I think there's a problem with the snap point and angle for the junction. The junction snaps at 45 degrees off from where it should to be "in line" with the main drive shaft of the windmill, and it's about half a foundation to close to the windmill as well - if you run a series of vertical shafts downwards from the default junction, it ends up with the mill halfway through a wall.
#3
johnathon007 21 Thg02, 2018 @ 2:41pm 
Why has this still not been fixed?
#4
Snicker 21 Thg02, 2018 @ 3:55pm 
CKF was abandoned last year.
#5
johnathon007 21 Thg02, 2018 @ 4:42pm 
Nguyên văn bởi Snicker:
CKF was abandoned last year.
Oh that explains everything.
#6
< >
Đang hiển thị 1-6 trong 6 bình luận
Mỗi trang: 1530 50