商店页面
Archean
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测
Archean >  创意工坊 > Chip Patton 的创意工坊 > Badger Smart Quad [Survival Ready] > 讨论
Badger Smart Quad [Survival Ready]
描述 讨论1 留言12 改动说明
Chip Patton  [开发者] 2024 年 10 月 2 日 上午 7:13
BUG REPORTS
If you find that the autopilot does something unexpectedly or the STAB feature or any other issues, please post it here.

For pretty much anything but the auto-pilot, please give ways to reproduce the issue.

With the auto-pilot, I'll need to know your EXACT flight conditions when the issue occurred.

For example:
Actual indicators:
Altitude: 8,000 meters
IAS: 80 m/s
GS: 75 m/s
Heading: 23.1

AP Settings:
Altitude: 8,000 meters
Speed: 80 m/s
Heading: 23

And then what you did that caused it. For example, "Tried to perform a 180 turn from 23 degrees to ..."

Then tell me what happened. For example, "Craft rolled to the side and fell out of the sky."

This is far more helpful than "Fix your stuff, bro".
< >
正在显示第 1 - 4 条，共 4 条留言
mark 2 月 2 日 上午 10:32 
Flys great but ore scanner doesn't work for me. Added 1.7 firmware and still the same. Select any distance and the sea is detected correctly, land doesn't show at all and the ore selected just shows around the perimeter.
#1
Chip Patton  [开发者] 2 月 7 日 上午 2:51 
引用自 mark：
Flys great but ore scanner doesn't work for me. Added 1.7 firmware and still the same. Select any distance and the sea is detected correctly, land doesn't show at all and the ore selected just shows around the perimeter.

Hi Mark! I'm aware of this issue and it's due to a battery change made about 3-4 weeks ago.

I've not yet updated the ship yet simply because it was a very minor change. Essentially, if you go into drone mode and disconnect the ore scanner, and just the ore scanner and reconnect it to a power junction nearby the junction it is connected to, it will start working again.

The problem is the junction it is on is over-voltage and is unable to scan more than about 3 channels.

Hopefully that helps.

If you're willing to wait about a week and willing to rebuild the ship, it will be updated.
最后由 Chip Patton 编辑于; 2 月 7 日 上午 2:52
#2
mark 2 月 9 日 上午 3:38 
Hi Chip, thanks for teh quick reply, tried to re-connect to two of the junctions that are nearby, no change. Update, got the ore-scanner to work by replacing it, though terrain scanner now not operational
最后由 mark 编辑于; 2 月 9 日 上午 10:54
#3
Chip Patton  [开发者] 2 月 11 日 上午 9:16 
引用自 mark：
Hi Chip, thanks for teh quick reply, tried to re-connect to two of the junctions that are nearby, no change. Update, got the ore-scanner to work by replacing it, though terrain scanner now not operational

I've published a fix. You have to redownload.
#4
< >
正在显示第 1 - 4 条，共 4 条留言
每页显示数： 1530 50