2-wide cockpit blocks, to allow for even-width planes

Hey Consty, this mod is amazing. Great work!
There is one wing block I didn't see in the pack: would it be possible to add a Slim Wing Inverted ROUNDED Corner? :)

4-long slopes and 8-long slopes with corner and inverted corner versions as well
plane blocks, that is

Large jet engines :)?
Propellors balanced against the engines built by you?

corner button panels like ramps

MFD blocks without the sun shade thing. Also, an MFD block with 4 small LCD panels

some new cockpits will be very good addition
and new engines like f-104 or mig25
and some new vent blocks looking more like engine intakes

this mod is amazing, it makes it possible to make very realistic and small fighters in space engineers, hats off to you sir

here are some suggestions.

more gun parts (armored) with a smaller size that can be use in a group
such as: MG 2x1 sloped block gun
MG 4x1 corner block gun
MG 4x1 sloped block gun
(I understand the 4x1 is a bit stretch however seeing that you have those block available id say might as well make it as a gun too

wing pylon 1x1 only?

More wings (maybe forward swept wings design?


that and maybe make the canopy side plates air tight if possible

It would be nice to have some wing cuff/in-wing spotlights for landing lights. Maybe using the models for your round and half round missile detection but converted to spotlights for straight versions of wings to start.

If you are allowing us to dream, there would also be some angle version that would match with the angled wings and allow you to fill a light in and then continue the angled wing.

Push propellers would be nice.
We have propellers with forward thrust already which is nice for most plane designs, but some planes, like ultralights or flying wing designs usually have their propellers mounted backwards, still providing forward thrust.

can you not just use the regular props and put them on the rear, and place a cone to cover it?

Oh thanks, didnt notice that you can place the propellers backwards and that these cones even exist

I wanted to ask if the Fighter HUD (the singular one with the AOA indicator on the left) can have lights to be triggered and if they can be activated programatically. I have a rather extensive Jet operating system, and it would be nice to use the three symbols for my AOA display. If its not possible, thats oki :)

only visual unfortunately

Can you do a 1x3-1x10 aircraft lightweight armored block and possibly do the slope too as 1x3-1x10. To utilize space and block limits if you Don't mind. If not I understand