安装 Steam
登录
|
语言
繁體中文(繁体中文)
日本語(日语)
한국어(韩语)
ไทย(泰语)
български(保加利亚语)
Čeština(捷克语)
Dansk(丹麦语)
Deutsch(德语)
English(英语)
Español-España(西班牙语 - 西班牙)
Español - Latinoamérica(西班牙语 - 拉丁美洲)
Ελληνικά(希腊语)
Français(法语)
Italiano(意大利语)
Bahasa Indonesia(印度尼西亚语)
Magyar(匈牙利语)
Nederlands(荷兰语)
Norsk(挪威语)
Polski(波兰语)
Português(葡萄牙语 - 葡萄牙)
Português-Brasil(葡萄牙语 - 巴西)
Română(罗马尼亚语)
Русский(俄语)
Suomi(芬兰语)
Svenska(瑞典语)
Türkçe(土耳其语)
Tiếng Việt(越南语)
Українська(乌克兰语)
报告翻译问题








The internal reservoir has a capacity limit now.
Gases aren't being filtered into the output correctly. I suspect this is why the Gas Filter has two outputs.
Even when the reservoir is full, it still seems to be running a check for pumpable gas. This was a problem with the old pump too — it caused noticeable lag if left on.
Disconnecting the pump from power completely stops all output.
Toggling filters (checking/unchecking) drops canisters.
1. The limit is always there (10t)
2. Fixed
3. In progress
4. Fixed
5. Fixed
Re1: I must of not noticed the limit before.
After update this morning I did notice it lags with filters. By that I mean it seems like gas packets are slower, I added a signal switch to it and it seemed to speed it up for some reason.
You still have to toggle it, but the signal switch seems like a better solution than `sift+d`
I could be wrong but it seems like there is a smaller range on it which I think is good prevents lag-out when (stupidly/greedily) clearing large areas
Overall I'm glad to see this project getting some love. <3
P.S. But I don't notice any lags even before, might due to my computer is too beefy to notice that. I'll try to play a bit more till it starts to lag and try it sometime and see if this occurred now.
Next up will be range slider.