商店页面
Transport Fever 2
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Transport Fever 2

商店页面
Transport Fever 2 >  创意工坊 > marc345 的创意工坊 > Cable car > 讨论
Cable car
描述 讨论2 留言169 改动说明
marc345  [开发者] 2020 年 9 月 30 日 上午 2:28
Known Bugs
Unfortunately UG has not answered to my bug reports and questions for over two months now.
In June the communication was a lot better and they added the vertical feature and fixed bugs super fast. I don't know what happened since then.

Therefore there are still the following problems:

1. Vehicles stutter and accelerate over the speed limit and then decelerate instantly. That's why they are stuttering in the stations.

2. Vehicles sometimes miss the stop point and open the doors too late.



3. Chairlifts don't support left hand driving. Will be fixed soon.
4. Waiting cargo on top aerial station wrong. Will be fixed soon.
5. Sometimes gaps in the cable. No other known solution yet.
最后由 marc345 编辑于; 2020 年 10 月 17 日 下午 1:20
< >
正在显示第 1 - 7 条，共 7 条留言
lollus 2020 年 10 月 3 日 下午 5:44 
Sorry mate, a nit: stdout says:
[RESOURCE ERROR] Referenced ground texture not found: '<empty string>' in 'Seilbahn_Gleis_station.lua' (has been replaced with fallback)
#1
marc345  [开发者] 2020 年 10 月 4 日 上午 12:32 
Does it crash? If not that‘s not super important but I will have a look into it.
#2
lollus 2020 年 10 月 4 日 上午 1:47 
No crashes, it works fine.
#3
lollus 2020 年 10 月 4 日 上午 1:55 
BTW: the stutter, which I did not even notice, may have to do with the edge/node "tangents". UG does something funny there. They are not tangents proper, more like sin and cos multiplied by the edge length (obtained with Pitagoras). But for some reason, straight edges can be fine with 1, 0, 0 or 0, 1, 0 r 0, 0, 1, regardless of their length.
Cables may gap because the camera is too close, which always makes things disappear.
#4
marc345  [开发者] 2020 年 10 月 4 日 上午 4:10 
No cables gap because of track settings I had to change and one doesn't work like everything else. I had to disable it which makes gaps in the tracks.
My edges and tangents are the correct length and corretly calculated. It's an UG bug.

I will have a look at the stdout message
最后由 marc345 编辑于; 2020 年 10 月 4 日 上午 4:11
#5
TheSilverYob 2022 年 1 月 8 日 下午 1:12 
I have an issue where I have done everything exactly like it says to in the video however the line wont link properly. I looked through and I don't have any signals that are messed up.
#6
marc345  [开发者] 2022 年 1 月 9 日 上午 1:30 
Add me and send me some photos, I will help you.
#7
< >
正在显示第 1 - 7 条，共 7 条留言
每页显示数： 1530 50