订阅以下载
TNPGS-PG_Generator Assembly

This Generator Assembly blueprint is a subgrid projection for the Power Generation building at the Titania Nuclear Power Generation Station; the station's blueprint is here:

https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2418983432

STATISTICS
Blocks: 44
PCUs: 526

INSTRUCTIONS FOR BUILDING IN SURVIVAL MODE WITH A PROJECTOR
The associated pictures show the installation sequence for a single generator; four generators need to be built.

1. The station's Power Generation building's four generator rotors should already be built.

2. Install an interior wall block onto the rotor head, orienting the top of the interior wall block outward.

3. Build the interior wall block to 46% using 20 interior plates and 1 construction component for the correct visual appearance and toughness.

4. Build a projector on top of the interior wall block with the front facing outward, i.e., away from the rotor.

5. Load the TNPGS-PG_Generator Assembly blueprint into the projector.

6. Build the generator. For the correct visual appearance for each generator, build each of the 7 heavy armor round slopes to 23% using 35 steel plates each, build the 8 heavy armor round corners to 16% using 23 steel plates each, and build the end interior wall block to 46% using 20 interior plates and 1 construction component; fully build everything else.

7. Remove the projector and replace with a heavy armor round slope. Build the heavy armor round slope to 23% using 35 steel plates for the correct visual appearance and toughness.

8. You're done.