Cities: Skylines

Cities: Skylines

318 个评价
Six-Lane Road with Bike, Bus and Tram Lanes, Decorative Trees
   
奖励
收藏
已收藏
取消收藏
Assets: Road
文件大小
发表于
19.816 MB
2017 年 12 月 9 日 上午 4:30
1 项改动说明 ( 查看 )
您需要 DLC 才能使用该物品。

订阅以下载
Six-Lane Road with Bike, Bus and Tram Lanes, Decorative Trees

在 ifriqiya 的 1 个合集中
Ifriqiya's Six-Lane Roads
22 件物品
描述
A large avenue, decorated with trees, with reserved lanes for bikes, buses and trams on its sides.

Decorations lower noise pollution and increase the land value.

Characteristics
  • Available in Large Road, Bus and Tram tabs, after your town has reached a population of 5,000 cims.
  • Size: 32m wide (4 cells).
  • Top speed: 60 km/h.
  • Cost: 140/cell.
  • Maintenance: 1.92/cell.
  • Noise Pollution: same value as the standard six-lane road with decorative trees.

You need Snow Fall and After Dark DLCs to use it.

You can see other variations in my collection of roads.

Please rate and comment. Thank you!
19 条留言
PsychoactiveSushi 2023 年 5 月 29 日 下午 6:04 
Why does it desubscribe???
SOMETIMES 2023 年 2 月 5 日 上午 8:23 
Would be perfect if only bus and tram lanes were separated.
Shellyships 2023 年 1 月 26 日 下午 4:33 
Not sure about the other people, here, but this road works well for me!
I absolutely adore this road. It's probably one of the best roads for trams. I think it's fantastic that the trams are on the outside, there's trees AND a protected bike lane!
VNDK8R 2022 年 9 月 16 日 上午 4:44 
An exception occured during NetAI simulation step.
Asset: 1226045581.Large Road Elevated0
SegmentID: 28424
Type: RoadBridgeAI
Severity: High

System.TypeLoadException: Could not load type 'Problem'.
at (wrapper dynamic-method) RoadBaseAI.RoadBaseAI.SimulationStep_Patch2 (RoadBaseAI,uint16,NetSegment+) <0x01d1b>
at HealkitMod.Patches.NetManagerPatch.SimulationStep (NetAI,uint16,NetSegment+) <0x0004d>
BoroMiR 2022 年 9 月 10 日 上午 11:36 
No passengers come to the stops. Buses and trams are running empty.
XanArc 2022 年 8 月 20 日 上午 9:49 
To clarify what I think the one-way version of this road would look like: the bike lanes, pedestrian paths, and trees would remain the same. The 6 main lanes would all go in one direction. 5 of those lanes would be regular car, while the 6th one would be for bus and tram. The tram wires/poles would not extend over the entire road but would only stick out over the tram lane.
XanArc 2022 年 8 月 19 日 下午 6:27 
I would really like it if there was a One-Way version of this (and all your other) road(s). Also would be nice if there was also One and Two way, four and two lane version of this (and all your other) road(s)
markthered 2022 年 7 月 8 日 上午 9:55 
Is there going to be smaller versions? Or Split? One with just 2 lanes going one way with the bus/bike lanes. Or two lane road etc
mjm92150 2020 年 9 月 26 日 上午 2:52 
Hello,
All your road are very nice.
I am just wondering if you are going to do it another road as :
1 way for vehicle only and both side only for bikes, buses and tram ?
I mean all cars/truck are in the same way and buses/tramway/bikes, are in both way.
Is going to be great to get it for this one and all your road too.
By the way, very great job you did and thank you very much for sharing your hard work.
Well done !
Tarsis 2020 年 6 月 7 日 上午 3:16 
I love all of your roads, but they doesn't seem to work with Traffic Manager. The Bus lane turn direction can't be changed and the traffic AI doesn't use the bus lane correctly (regular cars keep using the lane).
Unfortunately Traffic Manager is essential and road networks need to work with it. Currently using TM:PE v11 at the time of writing.

Any chance of fixing this issue?