The Talos Serious Editor 4 Beta is very nice but there are a few big problems. I hope you can/will help me. I keep getting this error where it says that a model in the mesh is local. And no matter what I do or save, it works fine but I keep getting this message. Then I saw this option to open the model in the ...commander . I can only make this screen smaller but I can't close it. And when I try to uncheck boxes in the View settings.... the main workspace disapeares and also the bar whith 'view-settings'. The only way I know to reset the editor to default is by deleting every entry in the Register that refers to it and than re-installing the editor. I did that 3 times now. So is there a way to get the editor to standard/default config/settings without reinstalling it and editing the register? And how can I save the mesh so it is saved well? I hope you can make sense of all this. THX