(Sorry for the long answer) I understand you. Thanks for the good air defense, and the developers of stormworks for such a "good" radar system and countless patches that break everything

I'm sorry to say, but I'm pretty sure this system stopped working a few updates ago, from what I gather the engagement radar will now track it's own missiles in flight, I'd have to redesign the tracking system entirely. Additionally a few updates before that the 3096E stopped working. I've pretty much abandoned this game for that exact reason, it's no fun putting months of effort into something just for it to be broken by an update you have no control over.

constant misses on non-maneuvering targets

dont track missile

Connecting multiple TELs to the same radar would be difficult but theoretically doable, I'll consider making it possible in the future. And it sounds like the missiles aren't receiving target data, make sure that you are have the target properly locked

The missiles don't track ? What's the min engagement, they seem to go up supper high and then disappear.

This is exactly what I have been looking for, only one thing, can you connect multiple launchers to the same fire control. As in if you want to have more than 4 launches, do you have to respawn all three vehicles, or could you have more than one launch vehicle.

Thx and new,radar cant detect small rocket why?

Ok I updated it, I removed datalink from the boot screen because the original radar (TPS-8) didn't have it, when that radar gets it I will add it to this

Ok thanks

Datalink does work I was just too lazy to update the screen, I’ll do it next update

It worked but during the checklist there is a datalink option that never works how do you connect the datalink?

ok I will do some trouble shooting

Yeah make sure the safety release is turned OFF (I will change how it works next update), also make sure you don't turn the array drive on until after the system has fully started

Ok so when I turn it on without the safety release turned on i get a blue screen. But when i turn it on with the safety release turned on i still get a black screen

yeah i dont know either i think everything else works its just that the screen doesn't turn on when i do the system console power switch

I don't know the issue then, it's worked perfectly fine for me

I did that nothing shows up

Raise the array outside, make sure the safety is off, go inside and turn on system/console power, when you see the map turn on array drive

The detection radar still cant turn on though

The checklist of the 30N6E is inaccurate, I will change it, you don't need any cables for this system

It says to connect a cable where do i connect the cable too and also the truck battery and truck gen always read 0.

It's really self explanatory, drive the vehicles to where you want them to be (preferably with open space), go into the truck with the engagement radar and radio array, raise the radio mast and turn it on, extend the stabilizers and deploy missiles using other buttons. After that the system is pretty much ready, aim the radar at whatever target you want to no longer exist and fire. Targets indicated by the detection radar should show up on the map to your right.

Pls make video how conect

Put the physics quality as high as possible, as lower physics decrease pivot strength

so uh, the missiles dont deploy. the pivots turn but the platform doesnt