@Martini_RoyaleHD ok, probably the editor didn't take the decimal point and I didn't notice. Thanks.

I've been working on an update for these highways for a very long time now. I hope to finish it before CS2 is released :-D Free time is always tight.

https://imgur.com/qojMtwn It can be fixed by changing the offsets, but it's weird since all the other networks work fine.

Doesn't happen all the time, but when creating an in/off ramp, some of the points in IMT are offset by a lot.

@Martini_RoyaleHD can you give more details? I have used it regularly but never had a problem using it.

IMT doesn't work propperly with this road

@deadtram very strange. I am not having this problem. I see it in the menus correctly. Maybe a conflict with some mod?

this road doesnt apper in game anymore (even in Findit)

@Sikari_Mizunomi good that you solved :-) Yes, with the offset at 0, in practice, nodes is crushed, as if it were not there.

@SimoG Sorry, I found the solution just soon: Using Node Controller, if one offset is 0m, then this problem occurs. The lines which didn't appear appear normally by giving only 0.01m to offset value.

@Sikari_Mizunomi I did not understand, do you mean that you draw a line with IMT and this is not seen over the road or do you mean that with some combinations of my roads lines do not appear and you have to complete them with IMT?
The second is normal behavior due to CSL limitations.
However, I am working on a substantial update of the roads (I'm transforming them into Adaptative Network Roads, with the addition of new features), which reduces these cases, does not eliminate them, anyway.

@macsergey Thanks for the feedback Added to the list :-)

this road has one lane width 378 instead of 3.78

Please, can we have a version without the guardrails on terrain mode? And with dirt on the sides instead of pavement. Thanks!

As I can see, fix never came. Also there's an issue with CSL Map View: https://imgur.com/a/nU93ebr (probably caused by same issue)

@Quboid Thanks for the report. I am checking now. Indeed there are a couple of lanes on the bridge with a negative value. But I don't understand where it came from. I also noticed another error with a missing decimal sign, always in the width of another lane. Tomorrow I try to make corrections and upload it.

I'm having some trouble with this in Intersection Marking Tool. When using the Elevated version, some of IMT's connection points are positioned far from the actual network - apparently this is because of negative lane widths? This problem doesn't occur with Bridge or Ground variants.