Butiksside
Avorion
Alt Diskussioner Skærmbilleder Illustrationer Broadcasts Videoer Værksted Nyheder Guider Anmeldelser

Avorion

Butiksside
Avorion >  Værksted > TESLAs værksted > TESLA Industries - 'Lion' Bulkhead Module
TESLA Industries - 'Lion' Bulkhead Module
Beskrivelse Diskussioner0 Kommentarer4 Ændringsbemærkninger
4 kommentarer
< >
TESLA  [ophavsmand] 24. okt. 2018 kl. 15:37 
I'll see about changing it up. If it's too much of a problem I may just delete it and make a better one. One with bonus agility built in.
AHorse 24. okt. 2018 kl. 14:29 
Fitting two of them into a 2-wide results in an odd gap between the 'back side' connectors, while a little bump in the middle touches.

On the other hand, if it didn't have the back side ports, and instead had the armor segments on both sides, it could make for some small gunships with heavy hardpoints.
TESLA  [ophavsmand] 23. okt. 2018 kl. 17:12 
It should be able to fit in a two wired connection point. I've been able to get it to work connecting to my other two wide pieces. Can you show me where it's a symmetric and I might can fix it?
AHorse 23. okt. 2018 kl. 13:56 
I'm having some trouble figuring out exactly when to use this. It's asymetrical, but doesn't fit in a two-wide configuration. Is it meant to face straight up/down?