One more fix. This involves yet again a similar issue that occured with FI in the past. Whoops.

Error fix for right inconsistent flashes. Not much to say.

NERFS. In all caps.
* Double Red, Green, Blue consistent release conditions have been nerfed to rely on one or the other timer now instead of both.
* Increased chance of getting a consistent flash. Chance of getting inconsistent flashes is now dropped to 36% in theory.
* TP Modified to now allow skipping time for releasing the button due to the nerf. Display timer will still require waiting however.
* Updated Module lists yet again, adding Not Maze, Cheat Checkout, Reverse Polish Notation, Etterna into their respective lists.
As expected, MANUAL REPRINT REQUIRED

Quality of Life Changes:
* Code condensed greatly yet again.
* For Right Consistent Red only, if there are no digits in the serial no. the module will proceed to the next "Otherwise"
* Fix a minor calculation error for Stage 2. Whoops.
* Now striking on a completed stage is a thing of the past.
* The TP help message has been partally changed. Commands can still be used as normal.

Lists updated to reflect the release of more modules.
* Updated the following lists: RT Controlled, RT Sensitive, Kritzy's Modules, Speakingevil's Modules, 3 Stage Modules
At some point, I'll need to make a spreadsheet for that above.
* Squashed more manual errors. This time on inconsistency errors with "numerical" and "numeral"
Manual Reprint Required

* Step 18 for stage 1 is not calculated properly, this is now fixed
* Changed a date for the special case
* Due to major changes to some modules being "blanked out" the footnote in the manual has been updated to reflect these changes
* Limit to 1 start-up sound from BTK being played
* Extend logging for of the edgework/module steps
* Modify TP Handler
* The last 2Factor release condition now has an example
* Other Manual Changes
MANUAL REPRINT REQUIRED

Hotfix. Fix an error the module detected a parallel port on the bomb and a magenta present on the given stage for "Determining the Correct Button section" for Stage 1

* Step 19 for Stage 2 didn't check as intended. This is now fixed.
* Added TP failsafe to auto-cancel if a sudden timer change caused the interaction to not be possible, and to prevent negative times.
* Add indication of what was done for that stage when a strike occured.
* To summarize above note:
- The left button indicates if you pressed the right button
- The middle button indicates within the given time range
- The right button indicates correctly holding/tapping the button and releasing the button with the correct conditions

Module Changes:
* Releasing the button with 1 Two Factor present changed to be easier, hopefully. This is due to the fact that Two Factor's can update more frequently if configured.
* Irregular flashes are more predictable now, repeat delay is now at base 2.25 seconds with the standard flash repeat delay still being at 1 second.
* "!# toggle" should now work for TP.
Manual Changes:
* Module Changes plus the following:
* Manual clarified to distinguish between irregular flashes and standard flashes
* I forgot to add 2 modules that technically have 3 stages, these are now included.
As expected, A MANUAL REPRINT IS REQUIRED

Hoxfix. One of the release conditions that can happen involves 2 sets of irregular flashes with the left being 0 and the right not being 0.