In order to build this medic you must have all of the following:
1180 or more max cpu
2 T10 electroplate R
2 T10 electro plate L
6 T10 walker legs
1 T9 electroplate R
1 T9 electroplate L
6 T10 nano tech guns
1 T7 electro plate L
1 T7 electro plate R
T9 radar jammer
28 T10 armored prisims
6 T10 armored tetras
257 T10 armored cubes

If you have all of the listed components you are ready to build.

After you have aquired all the parts to build you now start with building the body fo the bot.

1: You want to build a simple base around your piolit seat like is shown. make sure to leave the shown corners open as those spaces will be filled later.



2: you now want to go adding this tube like structer around your piolit seat. make sure to add it 7 cubes long on the front and 5 on the back.


now at one cube back from the front of the tube you want ot add this square tubes on both sides 5 cubes out.


now on the bottom of this you want to add these extra cubes and prisims


and on the front you want ot add these. make sure that you delete the bottom row of cubes in the center so that these will face flush with the rest.


now add a bit or armor using prisims and tetras as shown.


now the the front is doen move behind your piolit seat and start work on the rear.


you want to add these wing like fans on each side as these will act as gun mounts


After taht you want to add a layer on the back in the specific spots shown.


now you want to add some more on the rear as shown.


now you want to add this little design as this will maximize the defend you could get out of this area while still letting you add the rear leg later on.


once you have done this you are ready to move on to placein the movement seystems and hardware.

now that the chassi is done its time to move on to the electroplates guns and legs.

you want to place all plates in the locations shown below




make sure these T7 plates line up with the front armor. otehr wise you have built the front side too long or too short.




now for the legs. make sure these are SPECIFICLY PLACED other wise a few componets will not fit.









now finaly you add the radar jammer in the rear

The ATV-M-crawler MK:2 is a proven design to work in all gametypes. classic challenge and the battle mode. it works. it is mainly tuned to focus healing tactics as healing one teamate at a time tho you do want to hold right click when healing still.

this medic is still a ligher weight design and will not last long against thigns such as smgs.

in battle mode at very high over clock this thing can jump very high. and you should use that ability to jump at aircraft to attack them. and also use it to jump away from enemys when needed

the reason there is a rear leg is that this rear leg acts like an anchor of sorts. if you go right off a clif that would noraly make you drop that leg will hold you a bit and make you stick to the side rather than fall off a very sharp angled cliff. same goes with going up. for example: the ice hunks on the right side of the oen snow map and ontop of the mountian on the other you are able to climb them and go off the sides with out ever falling off them. and this is due to the rear leg acting like an anchor keeping you from simply falling.

now certian places on this bit could be more heavilyarmored byt this is the base version. if you have extra CPU a radar dish can be added same with radar reciver. design is not final. future versions are due.

previous version can be found here in the description.

enjoy your new medic.