缺氧
评价数不足
Water Gate(水门)
   
奖励
收藏
已收藏
取消收藏
文件大小
发表于
更新日期
810.536 KB
10 月 14 日 上午 8:11
10 月 27 日 上午 4:17
6 项改动说明 ( 查看 )

订阅以下载
Water Gate(水门)

描述
允许建立2格、3格、4格水门以及凝胶水门。

特点
✅ 2格水门通过不同材料决定了所产生的液体:
* 火成岩 → 盐水 + 水
* 花岗岩 → 乙醇 + 浓盐水
* 其他 → 原油 + 石油
* 下层液体的重量可在设置中单独配置。
✅ 3格水门从上到下依次包含:水、石油和原油。
✅ 4格水门从上到下依次包含:水、盐水、乙醇和原油。
✅ 凝胶水门建立的时候是一格,但生成的是101kg的液体凝胶。所以会变成2格。

使用方法
2格水门需要研究“水管”。
3格和4格水门需要研究“可再生能源”。
凝胶水门需要研究 "乳化"。

在 "实用"类别中找到它并使用吧!
32 条留言
n3mes1s 11 月 1 日 上午 10:47 
Sadly, despite the better looking of the granite gate, we cant use it on cold biomes cuz brine will completely freeze. Mod looking better now, i just wish you could rework the gates so we can use ethanol+something else like oil to use em on cold biomes.
n3mes1s 10 月 28 日 上午 10:40 
TetsuRemo Ethanol is not an early game liquid. Sure it can be harvested from seals, but until you can actually build a sustainable setup for em and bonbon trees, it can take many many cycles. I usually use the same ethanol produced by seals to make a cooling loop for my bonbon trees. The ethanol produced by seal is barely significant you need tons of em.. so it takes A LOT of time.
icon41gimp 10 月 27 日 上午 11:49 
For a cold based gate what about ethanol and liquid carbon dioxide? Obviously not useful most of the time but more of a specialized option.
TetsuRemo  [作者] 10 月 27 日 上午 4:18 
@Igawa Asagi 设置里只能改最底下那层的质量(2,3,4格这三个水门),上面部分现在是固定的。四格的乙醇是我漏掉了,现在应该没问题了。
Igawa Asagi 10 月 27 日 上午 1:52 
大佬,四格水门的乙醇量太大了有120g,导致乙醇会流向两边,在设置里调整最底层的量也没用,四格水门里乙醇一直是固定的120g,可以把乙醇的量改小一点吗
TetsuRemo  [作者] 10 月 26 日 上午 11:34 
@n3mes1s I don’t want to ruin the gameplay experience, so liquids unlock gradually with tech progression. The liquid in the 2-tile water gate can be obtained early, so it’s in the initial tier. Since the Printing Pod can spawn Oilfloaters and ethanol can be produced from Seals, I think crude oil, petroleum, and ethanol are all early-game liquids.
I really like ethanol’s color, but I avoided using DLC liquids like Nectar or Mercury to keep it compatible for players without the DLC. Instead, I used concentrated brine, which also looks great.Are you suggesting I remove one of the 2-tile water gate categories and keep only the crude-oil-and-ethanol combo?
If your liquid collapses, it’s likely because the bottom mass is too high without tiles around it. If you use it with open sides, set the slider to 0.03 (30 g) in mod settings — this keeps liquids stable even without blocks. I set the default to 111 g since I often use the “凹” double lock.
coolbitch 10 月 26 日 上午 6:48 
Thank you for the fixes!
没有烦恼的猫 10 月 26 日 上午 3:12 
老师谢谢你的付出,mod可以用了
TetsuRemo  [作者] 10 月 26 日 上午 12:03 
@没有烦恼的猫 不好意思,现在改好了,再试试看呢😂
TetsuRemo  [作者] 10 月 26 日 上午 12:02 
@n3mes1s I just checked the freezing points on the wiki, and besides the new DLC stuff, Brine freezes at -22.5°C - that should be totally fine. I think the one you mentioned with the super low freezing point is actually Salt Water, which freezes at -7.5°C.