Stormworks: Build and Rescue

Stormworks: Build and Rescue

51 个评价
XPIT | RS18 PERFORMANCE
   
奖励
收藏
已收藏
取消收藏
标签: v1.15.3
文件大小
发表于
更新日期
891.055 KB
8 月 29 日 上午 9:10
9 月 13 日 上午 3:44
9 项改动说明 ( 查看 )

订阅以下载
XPIT | RS18 PERFORMANCE

在 ølkongen 的 1 个合集中
XPIT
8 件物品
描述


While being heavy on fuel it's heavy on bringing you wherever you want whenever you want. Arid and Sawyer being short minutes apart. Not tested but it could probably time travel if you slam it hard enough.


Specifications

Guests: 16 People
Engine: 4Cyl 5x5
Jets: 3x
Top speed: 130M/S, 250Knots



Update:
- New screen to replace engine start buttons
- New Performance Sport screen
- Towing Support
- Improved Stability at high speeds



CREDITS
ZE Modular Engine Controller
ZE Modular Clutch
Buunuu 3D Map
Throttle Screen





If you're making a modified version and want to upload it make sure to leave a link to the original ;)
29 条留言
ølkongen  [作者] 9 月 28 日 上午 3:01 
You have to start engines via the small monitor. press the "ENG" button
rowanlooney 9 月 27 日 下午 12:11 
the boat wont work it does not start or go
ølkongen  [作者] 9 月 22 日 上午 10:37 
There is this "bug" or what you will call it where you place them next to each other and it makes the boat float better. Quite usefull since the boat would realisticly be built in a lighter material and therefore not sit so deep in the water anyway.
twzb.ttv 9 月 22 日 上午 8:34 
question why are there a bunch of unused robotic pivots?
ølkongen  [作者] 9 月 13 日 上午 3:46 
If you are using the latest update from today the refueling can be connected on the floor next to the left (port) door. Charging can be connected at the back on the port side of the rear hatch / sunpad
victimiser 9 月 13 日 上午 2:38 
where do i refuel?
and charge
avikdass 9 月 5 日 上午 8:13 
Thx
ølkongen  [作者] 9 月 4 日 下午 9:24 
Sit in the drivers seat and looking forward you will see a small screen with a box saying ENG press E on the box to toggle engine. Also tab for third person
avikdass 9 月 4 日 下午 9:15 
also how do i go in third person
avikdass 9 月 4 日 下午 9:14 
im new and i cant figure out how to start the engine