Abonner for at downloade
[6.0.x] Compatibility submod for Alternative Unit Cards and Scrap Upgrade UI Framework

Credit to Alternative Unit Cards by r1kko - https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2789914172
Credit to Scrap Upgrade UI Framework by BAGHolder - https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=3384239916

Warning - this submod uses AI 2x upscaling and a lot of image detail is lost and/or looks frankensteined. Otherwise, it would have been too blurry for my liking.

This submod enables compatibility between the Alternative Unit Cards and Scrap Upgrade UI Framework mods. The vanilla Scrap UI by CA uses the 120x260 large unit cards located in ui/units/infopics and normally, unit cards are located in ui/units/icons in a 60x130 size. If you use the two mods as is, then the vanilla unit cards will be shown in the Scrap Upgrade UI instead of r1kko's.

Tool used is Upscayl at https://github.com/upscayl/upscayl. Batch settings set to 2x scale and using the "General Photo (Ultrasharp)" model.

The following steps was done:

1. Extract all the 60x130 unit cards at ui/units/icons from the Alternative Unit Cards mod.
2. Extract the ui/units/infopics/infopic_mask.png image file.
3. Launch Upscayl, set up the batch settings and then batch upscale all of the 60x130 unit cards into 120x260.
4. Open up Photoshop and select the transparent background of the mask and make it black. Then inverse select and then delete the content in the middle to create the large unit card frame.
5. Record a Photoshop action that places the edited large unit card frame on top of a 120x260 large unit card, export to PNG and then close the image file.
6. Now you can begin the Photoshop automation and have it use the recorded action and set the Destination to "None".
7. Open up the submod in RPFM and import all the new 120x260 large unit card into the ui/units/infopics folder.
8. Done.

OR (courtesy of @Huppias)

1. Extract all the 60x130 unit cards at ui/units/icons from the Alternative Unit Cards mod.
2. Extract the ui/units/infopics/infopic_mask.png image file.
3. Launch Upscayl, set up the batch settings and then batch upscale all of the 60x130 unit cards into 120x260.
4. Record a Photoshop action that places the mask on top and the unit card on bottom, creates a clipping/cut mask on the mask itself and exports it as a PNG.
5. Now you can begin the Photoshop automation and have it use the recorded action and set the Destination to "None".
6. Open up the submod in RPFM and import all the new 120x260 large unit card into the ui/units/infopics folder.
7. Done.

You can load this submod before or after the 2 required mods.