Space Engineers

Space Engineers

Otillräckligt med betyg
ISL - Hiruda MK3-IC 1000 Hybrid Thrust Constructor
   
Utmärkelse
Favorit
Favoritmarkerad
Avfavoritmarkerad
Type: Blueprint
Taggar: ship, small_grid
Filstorlek
Lades upp
2.692 MB
25 sep, 2020 @ 10:20
1 ändringsnotis ( visa )

Abonnera för att ladda ner
ISL - Hiruda MK3-IC 1000 Hybrid Thrust Constructor

I 3 samlingar av Spite
ISL - Small Grid Printable Ships (with Printer)
185 artiklar
ISL Shipyard
218 artiklar
ISL - Utility Ships
47 artiklar
Beskrivning
"it does everything, it grinds, it drills it even build's hell mount a pen on it and it could even do your taxes" - Engineer alt----f4

Purpose
A Medium ship for manual grinding and welding, with a wider operating range than its MK1 counterpart, being able to operate in planetary gravity, open space or lunar gravity, in exchange for a slightly reduced cargo capacity.

The Hiruda series is equipped with multiple connectors for more docking options, two gatling guns for defense, and a drill for clearing ground from job sites, as well as the essential grinder and welder.

Features
Tools, Scripts & Weapons:
1 Grinder
1 Welder
1 Drill - for clearing ground
2 fixed gatling guns
2 Landing Gear - underside
PAM script - for autodocking and gravity aligning convenience only, not for mining/salvage jobs.
Fancy Status Display Script - for cargo and power management

Power:
6 Large Batteries
5 Small Batteries

Movement & Control:
1 Cockpit
1 Remote Control
4 Gyroscopes
8 Large Ion Thrusters
42 Small Ion Thrusters
8 Large Atmospheric Thrusters
18 Small Atmospheric Thrusters

Cargo Space
1 Drill
1 Grinder
1 Welder
1 medium cargo container
4 connectors - Port, Starboard, Underside and Rear

Miscellaneous:
2 Spotlights
Navigation Lights
Repair Projector

This ship has an empty mass of 72669 kgs, and can move with a full cargo at a maximum tilt of 55 degrees below horizon.

All Programmable blocks are turned off in this blueprint and all toolbars are the same from the cockpit and remote control.

All ships in this set have a rear mounted Merge block and can be printed using a welder wall with one (large grid) piston. However in this design the merge block will have to be ground down if docking via the rear connector, all blocks that require removal are painted bright red.

Toolbars

Toolbar 1
1. Thrusters All On
2. Thrusters All Off
3. Thrusters Braking On
4. Thrusters Braking Off
5. Lights On/Off
6. Connector Switch Lock
7. Camera Po
8. Camera Sb
9.

Toolbar 2
1. Battery Discharge
2. Battery Recharge
3. Camera Front
4. Camera Underside
5. Camera Rear
6. Drill Control
7. Welder Control
8. Grinder Control
9. Antenna Broadcast On/off

Toolbar 3
1. PB [PAM] "up"
2. PB [PAM] "down"
3. PB [PAM] "apply"
4. Gatling Gun Control
5. PB [PAM] "Align"
6. PB [PAM] "homepos"
7. Landing Gear Switch lock
8. Hydrogen Tanks Stockpile On/Off
9. H2 Generators On/Off

Toolbar 6
1.
2.
3.
4.
5. Repair Projector On/Off