Tilaa ladataksesi
ISL - PhysaS-IC 900 Salvager

A medium ship for grinding, with front and underside mounted tools, including a drill for clearing away ground. The Physa is available in Grinder and Welder variants, as well as in each thrust type.

Multiple connectors allow for a variety of docking options, and it is lightly armed with two fixed gatling guns.

Although it is equipped with a conveyored drill, this ship is not recommended for use as a miner, find a collection of dedicated mining craft here.

Tools, Scripts & Weapons:
2 Grinders
1 Drill - for clearing ground, not for mining
2 gatling guns
PAM script - for autodocking and gravity aligning convenience only, not for mining/salvage jobs.
Fancy Status Display Script - for cargo and power management

Power:
3 Large Batteries

Movement & Control:
1 Cockpit
1 Remote Control
3 Gyroscopes
2 Large Ion Thrusters
49 Small Ion Thrusters

Cargo Space
1 Cargo Medium Container
2 Grinders
3 Connectors

Miscellaneous:
4 Spotlights - 2 Front & 2 Underside
5 Cameras - Front, Underside, Rear, Port, Starboard
Repair Projector

This ship has an empty mass of 25457 kgs, and can move with a full cargo at a maximum tilt of 30 degrees below horizon.

All Programmable blocks are turned off in this blueprint and all toolbars are the same from the cockpit or remote control.

All ships in this set have a rear mounted Merge block and can be printed using a welder wall with one (large grid) piston. However in this design the merge block will have to be ground down if docking via the rear connector, all blocks that require removal are painted bright red.

Toolbar 1
1. Thrusters All On
2. Thrusters All Off
3. Thrusters Braking On
4. Thrusters Braking Off
5. Lights On/Off
6. Connectors Switch Lock
7. Camera Po
8. Camera Sb
9.

Toolbar 2
1. Battery Discharge
2. Battery Recharge
3. Camera Front
4. Camera Underside
5. Camera Rear
6. Drill Control
7. Grinder Control
8. Grinders On/Off
9. Antenna Broadcast On/off

Toolbar 3
1. PB [PAM] "up"
2. PB [PAM] "down"
3. PB [PAM] "apply"
4. Gatling Gun Control
5. PB [PAM] "Align"
6. PB [PAM] "homepos"

Toolbar 6
1.
2.
3.
4.
5. Repair Projector On/Off