Butikssida
Empyrion - Galactic Survival
Alla Diskussioner Skärmbilder Konst Sändningar Filmer Workshop Nyheter Guider Recensioner

Empyrion - Galactic Survival

Butikssida
Empyrion - Galactic Survival >  Workshop > Zeals workshop
Otillräckligt med betyg
MCRN-Groundog-T2 Utility HV
Beskrivning Diskussioner0 Kommentarer3 Ändringar
   
Utmärkelse
Favorit
Favoritmarkerad
Avfavoritmarkerad
Blueprint: Hover Vessel
Taggar: Blueprint
Filstorlek
Lades upp
59.781 KB
11 feb, 2020 @ 9:51
1 ändringsnotis ( visa )
Skapat av
Zeal
Online
Se alla 3 samlingar
991 Unika besökare
136 Nuvarande abonnemang
9 Nuvarande favoriter

Abonnera för att ladda ner
MCRN-Groundog-T2 Utility HV

Beskrivning
A late-game multipurpose utility vehicle based off of jrandall's fantastic T1 Miner. https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1960704617

I added another generator, a tool turret, a fridge and upgraded the drills to lasers. It is also T2.

Use the custom command to retract the tool turret for mining and keep elevation at about 1.5m

Keeps same carrying weight as the original.

Requires Level 20 and rare resources except gold.
3 kommentarer
< >
bobo8734 11 jun, 2020 @ 19:43 
One thing that I found helps stability in v12 experimental is to stick one engine on either side of the middle of the HV, pointing down. This provides stability and a hair more lift, though not above HV norms. Had to remove one of the harvesters though and something else, but I can't remember what it was. Also, turned the roll adjustment to .1 that helps a bit.
Zeal  [skapare] 12 feb, 2020 @ 22:26 
Go ahead an do what you want with this. I'm still trying to get the hang of building ships in this game and taking apart your ships and putting them back together with upgrades has been very informative.
jrandall 12 feb, 2020 @ 11:49 
Thank you! I will check it out. I had troubles with leaning when building. I did adjust it some to get it better, but could never get it to be perfectly flat with a full load. If you want, I can also add this as a modded version on the original post. Thanks again!