订阅以下载
VAS Raptor Lander MkIV

The Victor AeroAstronautical Systems Raptor Lander Mk IV!
An Exploration-class ship.
Now with additional projectors!

The Raptor Lander (no correlation with the dino) is a large survival ship with immediate ability to leave planets and then land on other planets. Made for prospecting the wilds. Has no current weapons to allow end user to pick and choose. Multiple points are on the outer sides for weapon emplacements. Just grind down the blocks.

Equipped with a refinery, assembler, medical bay, 4 cargo containers, one cryotube, one jumpdrive, two oxygen farms, and one single cargo container not connected.
Two Fore fuel collectors (air vents for collecting oxygen).

Refinery and assembly have room for add ons.

Four nuclear reactors and two backup batteries for power. More than enough for supply power to additional projects.

Has two large hydrogen thrusters aft and ventral. Four small hydrogen thrusters on all side except aft.
While hydrogen requires regular fill ups, I've selected them to allow for multi-enviroment landing, powerful thrust, and reduced number of thrusters.
Using toolbar 2, and throttling as you land and take off should provide you with two complete cycles with a speed mod. One and a half if you are lucky at 100m/s cap.
I have the numbers set on thruster override for easy thumb access on *most* gaming mouses with numpads on them.

Port Projector projects an attachable living and production quarters, Starboard projector projects a hydrogen refinery complete with ramp and connector for the Raptor Miner.
See Raptor Miner Here: https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1641219854
The Raptor Miner does fit inside, be sure to make a block to connect too. To have the miner secure nside, Place blocks (about 4) in the front middle under the camera, then use a small grid landing gear. The load ramp needs armor slope 2x1x1 tips to make flush to the ground.
Current bp does not come with resources to make projected grids.

Please note on both projected grids - grind down block below connector once complete that way the lander may move away. Once both the Refinery and Living quarters are built, the living quarters may be moved together using the Raptor Lander!

Be sure to land fully with all landing gear on surface and locked before projecting.
When transfering the living quarters over to the refinery be sure it is level and switch to ship. Make sure it is level with landing gear off before pick up.
Move over close to other connector, lower slow and then connect. It is advisable to use another person to guide.

Tool bar 1 - General piloting
Tool bar 2 - Descent piloting
Tool bar 3 - Production



Compliments with VAS Contractor Truck https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1642340181

Enjoy!