Train Simulator Classic

Train Simulator Classic

111 个评价
Boxcars to Johnstown [JWH001]
   
奖励
收藏
已收藏
取消收藏
文件大小
发表于
67.908 KB
2013 年 2 月 18 日 上午 9:41
1 项改动说明 ( 查看 )

订阅以下载
Boxcars to Johnstown [JWH001]

描述
Pick up multiple sets of boxcars in South Fork and run them over to Johnstown using a Baldwin Centipede. It's a beautfiul spring morning with just a bit of mainline and side traffic. NOTE: This scenario is set to Cold & Dark, so you'll need to start the train before you start gathering the consist. Duration : 35 mins Difficulty : Easy
10 条留言
crlynch 2018 年 3 月 23 日 下午 2:28 
Great run enjoyed thanks found some more now .Cheers
[MO] Martin 2017 年 1 月 4 日 上午 9:32 
Nice trip, - thanks !
best regards
BarefootBoh  [作者] 2014 年 11 月 14 日 上午 10:31 
ShunterBill - http://www.railsimulator.com/resources/208318/fcd9ca9e1420ceb5bf830ed2140a0665/Baldwin%20Centipede.pdf has the startup-sequence

But here you go

1.- Connect the battery. So you get enough energy supply for the fuel pump.
2.- Pull the "Fuel Pump Start" button. The pump will turn on.
3.- Check the fuel pressure gauge and wait until the pressure reaches 12 psi.
4.- Pull the start button for 3-5 seconds. The engine should start.
5.- Once the engine is running, pull the button to connect the Aux Generator. If you forget to
connect the Aux Generator, the fuel pump, lights and any electric system will be kept running
only by the battery.
6.- Move the reverser handle, open the throttle lever and release the train brake. Drive the
train normally.

ShunterBill 2014 年 11 月 14 日 上午 9:42 
call me dumb but how do u start her HELP
western 2013 年 9 月 2 日 上午 1:02 
Not a bad little scenario
Bob 2013 年 3 月 31 日 下午 8:56 
Nice Job!
BarefootBoh  [作者] 2013 年 3 月 28 日 下午 1:21 
Glad you enjoyed it!
N1QGM 2013 年 3 月 28 日 下午 1:02 
A fun little run in one of my favorite pieces of equipment, the Baldwin Centipede. I especially like to start it from cold & dark...
Well done!
Thanks,
M.
harry.vandeberg 2013 年 2 月 22 日 下午 1:56 
nice
bosambo 2013 年 2 月 19 日 上午 10:38 
ok