Rgbs von lüfter und Gehäuse (phanteks xt view ) versagen ?
hi , steam community hat vielleicht einer eine Ahnung was das sein könnte :
habe nach der netz Trennung plötzlich keine Beleuchtung mehr an Gehäuse und Lüfter ,
vorher habe ich sie mit dem gigabyte controle center geregelt aber nun wird da nur noch die ram erkannt ? Mein Gehäuse ist das Phanteks xtview wie auch die Lüfter , zur info die Schalter am Gehäuse funktionieren auch nicht und das seit dem kauf (dubaro) ....reset und power tasten funktionieren !

alles schon neu installiert , nur eben windows 11 nicht ....da weigere ich mich noch !

Bin ratlos ?, die lüfter drehen sich noch.
< >
Showing 1-7 of 7 comments
smallcat Nov 26 @ 2:56pm 
Turn off the PC and restart . Check the cables . Change the ARGB header . Check if lights are enabled in BIOS
Texhex Nov 27 @ 10:35am 
Hi cat , I dont cant find the settings in gagabyte BIOS

Greetings
Texhex Nov 27 @ 10:37am 
Argb V1 V2 V3 are the Same ?
Texhex Nov 27 @ 11:06am 
its the Phanteks xt view tower , the reset and the power button work ,and the other 2 button not work ---- from day one
smallcat Nov 28 @ 6:26pm 
if the lights are wired to the mobo these 2 botton would do nothing .The case comes with a DRGB controller so the buttons could work.
_I_ Nov 28 @ 6:46pm 
make sure the lights are compatible with the mobo or controller you have it plugged into

argb is 3pin, will not work with 4pin rgb products

if the lights are rgb 4pin, you can physically plug it into the 3pin argb header, but it will not work
smallcat Nov 28 @ 7:03pm 
Connect the fans DRGB(ARGB ) to the controller . The controller itself is powered via a SATA power cable
Last edited by smallcat; Nov 28 @ 7:10pm
< >
Showing 1-7 of 7 comments
Per page: 1530 50