Black map problem :: Command: Modern Air / Naval Operations WOTY Tech Support

商店页面

Command: Modern Air / Naval Operations WOTY

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Command: Modern Air / Naval Operations WOTY > Tech Support > 主题详情

[TIGER]

拥有 Command: Modern Air / Naval Operations WOTY

2019 年 5 月 8 日上午 12:06

Black map problem

Hello everyone. i have the following problem. i start the program and i load the scenario that i am making and the map is black. is there any fix about that?
I tried settings from nvidia(i have 1070Ti) but still the same problem.
Thank you in advance

< >

正在显示第 1 - 4 条，共 4 条留言

Baloogan [开发者] 2019 年 5 月 8 日上午 12:53

Please take a look at the troubleshooting steps listed here: http://www.matrixgames.com/forums/tm.asp?m=3913597

Baloogan [开发者] 2019 年 5 月 8 日上午 12:54

As well as https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1374061499

[TIGER]

2019 年 5 月 8 日上午 4:32

Dear sir thank you for the reply. I made all steps and i had the same problems I could see the units but not the map. So I started "playing" with nvidia settings and i found the following:
Anisotropic filtering: Application controlled
FXAA: on
Gamma correction: On
Antialiasing - mode: Application controled
Transparency: Off
CUBA - GPU's : All
Maximum Pre rendered frames: Use the 3d Application Setting
MultiFrame sample AA MFAA: Off
Shader Cache: On
***Texture Filtering***
Anisotropic sample Optimization: Off
Negative LOD bias: Allow
Quality: Quality
Trilinear Optimization: On
Vertical Sync: Use the 3D application setting

I hope it will be helpful for those that have very good graphic cards. And works very smooth.

Thank you again.

最后由 [TIGER] 编辑于; 2019 年 5 月 8 日上午 4:44