You have to examine the wall panels to find the right size in the house. It is a pain in the butt. It is kinda silly as you could just cut the bigger piece. What I do is run around a house I am going to destroy and examine and grab most of the non-standard (150cm) wall sections.

引用自 Shawn：

I have orders for 120cm walls, but every wall I pull down is always 150cm

Where do I find 120cm?

Door frames, window sections, anything that looks cut from standard. I will find panels that count as pillars visually until you arrow over them like a wall.

Yes I agree there should be a saw in your warehouse where you can cut panels and wood to order. Also could cut-up furniture into something you can recycle.

most ware houses do have a saw compartment to shrink varius sizes
most times a extra service ya have to pay for.

looks like poland doesnt.

i assume they expect customers to do this at home.


A Typical Evening Livingroom Picture:

Leftside: mom irons the clothing <--> Rightside: Dad runs the table saw while watching the news channel.

Center: You sitting on the couch with your mobile , cutting down the 6pack Guinness to zero. :-)

引用自 kalyoth：

引用自 Shawn：

I have orders for 120cm walls, but every wall I pull down is always 150cm

Where do I find 120cm?

Door frames, window sections, anything that looks cut from standard. I will find panels that count as pillars visually until you arrow over them like a wall.

They are all still 150cm. Even if they scan as 30cm on the wall, as soon as I chisel them down they turn into 150cm

[edit] I'm working on taking some walls down in a T2 house, and these wall panels are staying the same size as the scanner shows on the wall. So I guess it is only T1 houses that only have 15cm wall panels

150 is the most common, 120 is rare and 90 is epic. Only thing to do is go around with scanner and check walls. Tier 1-3 houses fewer, 2-story houses there's around 10 or so 120, maybe 4-6 90.

There are times where I am having a scanner show a 30cm section on the wall, but when I take it down it turns into 150cm. It seems somewhat random rather they stay 30cm or not.

引用自 Shawn：

There are times where I am having a scanner show a 30cm section on the wall, but when I take it down it turns into 150cm. It seems somewhat random rather they stay 30cm or not.

This!! Today i was after the same walls 30, 120 and 90 and when i found them, using the tool to remove the wall intact, it transformed into 150cm....What the.....??? Decided to try other wall and the 30cm went to 90cm....but the 150cm sticks to it.
If any dev are reading this, please take a look at that please.
thanks.